| SYSTEMS
[Main Index] Last
updated
01-Dec-2009
|
| 15/04/02 |
FECO
3000 # 69/1 |
AMI MegaRAID 493 Elite 1600 Controller.
- Vision 7400 & 4455 Upgrade Procedures. Replaces
NCR3000 #69 |
| 18/02/02 |
|
Introduction of the NCR WorldMark 4455 Server
System. |
| 06/04/94 |
|
Netware/x - tuning the nvt time-out parameter. |
| 18/08/94 |
|
To introduce the SCSI differential daughter
board. |
| 18/08/94 |
|
Update - SCSI differential daughter board. |
| 26/09/94 |
|
On units upto tracer no. 36-001655
it is possible that the PSU fan has been installed incorrectly. The result
of this is that the airflow is incorrect. Airflow should be towards the
back of the unit across the power supply. |
| 30/09/94 |
|
NCR3350 AND NCR3410 8MB MEMORY
SIMMS errors |
| 21/11/94 |
|
To give the installation instructions for
a 3430 second processor support package. |
| 05/01/95 |
|
To introduce the SCSI single ended
daughter board. |
| 30/03/95 |
|
To advise different types of 4mm drives-
WangDAT & WangTEK |
| 03/08/95 |
|
NCR 3416 UNIX Loading Information. |
| 03/08/95 |
|
NCR 3000 SYSTEMS RUNNING UniVision. Flow
control problems have been experienced on the diagnostic modem when processing
long lists. |
| 29/01/96 |
|
AT & T have introduced a
new memory baseboard and simm's for the NCR3-3555. |
| 29/01/96 |
|
NCR 3350 NCR 3410 SCS1 HOST
ADAPTOR (PXA) |
| 09/01/96 |
|
Some NCR 3430 systems have processor boards
which are populated with potentially defective Intel SRAM chips. |
| 24/10/95 |
|
92-01 INTEGRATED NCR DISK ARRAY CONTROLLER. |
| 24/10/95 |
|
This feco applies to NCR3430
prior to fitting, or fitted with a scsi daughter card connected to the on
board connector, with a serial number below 36-25800230. |
| 22/09/95 |
|
To advise the current settings to multiple
external SCSI controllers installed into an , AT&T 3416. |
| 07/11/95 |
|
NCR 3430 SCSI DAUGHTER CARD - Hex stand
off wrong length. |
| 07/11/95 |
|
NCR 3450 FIRMWARE CHANGE TO INCREASE SUPPORT
FROM 8 LUNS TO 16 LUNS. |
| 15/08/95 |
|
To list the settings to be used to enable
the NCR 3430s on board SCSI to be used as the boot device whilst
also having 2 further SCSI installed. |
| 08/03/96 |
|
NCR 3000 6256/6299 Sub-Systems WITH ADP93
CONTROLLERS. |
| 08/03/96 |
|
ALL NCR / AT&T 3000 SYSTEMS -
Defence against boot sector virus. |
| 25/06/97 |
|
To upgrade firmware to overcome drive problems. |
| 20/04/96 |
|
NCR 34XX/35XX REFERENCE DISKS |
| 15/04/96 |
|
Introduction of new line status table unique
flex/rigid SIMM. version 2 disconnect memory board for the 5100 series and
345x series |
| 15/04/96 |
|
NCR 3000 SeriesGeneral information on serial
I/O stargate controllers. |
| 23/04/96 |
|
GLOBALYST 520/530 - Overcome Unexpected
System Halt. |
| 14/05/96 |
|
NCR 345x/35xx -Two issues with reference
diskette. |
| 24/02/97 |
|
ONEAC UPS ON NCR 3000 SYSTEMS. |
| 19/04/96 |
|
To identify and record SIMM
failure. NCR 345x 355x 5100 Systems - Memory Simms |
| 11/06/96 |
|
All NCR 34xx & 35xx Systems-Firmware
Upgrade to 2.01.01.2 |
| 02/08/96 |
|
Amendment to FECO - TB473 was
numbered as 34/35xx#, which was incorrect. |
| 04/11/96 |
|
NCR 3430 system - Timing errors between
system board and SCSI controller. |
| 03/04/97 |
|
Incompatibility between old and new versions
of the PCB and system bios. |
| 03/03/97 |
|
To upgrade S40 system to a Dyadic 166MHZ
processor. |
| 05/06/97 |
|
NCR 3438 (S40) - Incompatibility between
Ethernet PCB and system bios. |
| 23/05/97 |
|
Installation instructions for an ISA digiboard-8,
installed in an S40. |
| 24/06/97 |
|
Introduction of a new NCR 4300 MEMORY BOARD. |
| 02/05/97 |
|
NCR3438(S40).NCR3446(S46),4300 Adding fourth Adaptec AHA2944W adapter
causing garbled characters.
|
| 02/05/97 |
|
Display of erroneous error. |
| 02/05/97 |
|
NCR 3446, S46, 4300 INCOMPATIBILITY OF SIMMS.
|
| 20/06/97 |
|
NCR 3438 S40 Corruption of Bios. |
| 25/06/97 |
|
NCR 4300 - Incompatibility with different
types of system base board. |
| 03/07/97 |
|
4300 systems may potentially
power themselves off due to an over temperature condition. |
| 23/08/99 |
|
Introduction of the NCR S20GX which replaces
the existing NCR S20LX. |
| 28/11/00 |
|
Problems - 18GB disks into an NCR 4300 with
a MYLEX DAC960PL Controller. |
| 30/03/01 |
|
Equipment becoming obsolete - NCR 4300 -
MYLEC DAC960Px CONTROLLERS. |
| 04/11/96 |
|
Earlier version Firmware issue - mylex dac960pl
pci array adapter. |
| 19/01/95 |
|
To release additional information on the
NCR 4090/4098 UPS. |
| 18/08/94 |
|
Release of new disk - NCR 6091 - HEWLETT
PACKARD 1.05GB DISK. |
| 10/06/94 |
|
Amendment to TB411 FECO 6000 # 59. |
| 28/03/95 |
|
To release the HEWLETT PACKARD C3323 1.056
Gb SCSI disk drive. |
| 06/06/95 |
|
To release the HEWLETT PACKARD C3724S
1.2Gb single ended SCSI disk drive. |
| 07/11/95 |
|
M6000/7000/8000 Systems, incompatibility
of CCB settings when replacing 1.2Gb disks. |
| 07/11/95 |
|
To release the FUJITSU M1606SAU 1.08Gb
single ended SCSI disk drive. |
| 06/01/95 |
|
To release the SEAGATE HAWK 2XL ST31051N
1.05Gb single ended SCSI disk drive. |
| 07/08/97 |
|
To document modifications necessary
TO/ETC/TTYDEFS to support RIO DRIVER V1.02 and a 3 wire hook-up. |
| 07/06/01 |
|
Introduction of new system -
The Vision 7400 is the new System being marketed by EDP. |